KL20 LED Lamp
This is a high-efficiency LED luminaire which, thanks to its modular structure and lengths from 30 cm to 2 m, adapts to the lighting needs of hoods and ceiling extractors of any size. Its design allows it to be installed flush with the stainless-steel panels used in professional kitchens.
- Colour: Anodised aluminium
- Flush mounting
- Suitable for indoor and outdoor use
- Dimmable with power supply
- Length [mm]: da 300 to 2000 mm
- Width [mm]: 63,15 mm
- Height [mm]: 18,4 mm
- Nominal voltage [V]: 48 V DC
- Maximum power [W]: 6.2 W
- Effective luminous flux [lm]: 610 lm (4000°K) – 558 lm (2700°K)
- Colour temperature [K]: 4000 – 2700
- Colour rendering index > 80
- Estimated life: 50,000 hours
- Illumination angle [°]: X135/Y125
- Efficacy [lm/W]: 99 (4000°K) – 90 (2700°)
- Connection type: IP68 specific connector
- Range of cable cross-sections used [mm2]: 0,75
- IK rating: 09
- IP rating: 65
KL-20 is available in two light colours, 4000°K and 3000°K.
Available in various lengths on request (as a modular lamp) from 3 modules (31.3 cm) to 20 modules (201.3 cm).
KL-20 is supplied with IP68 male connector and 2 metre female connector cable (1 and 3 metres optional).
*Technical data valid for single 10 cm module
Would you like more information on the LED KL20 Lamp?
How to install the KL20 LED lamp
KL20 is designed for panel mounting. A groove must be made in the panel where the installation is to be carried out, with measurements in accordance with the length of the lamp.
The recessed area of the KL20 is provided with double-sided adhesive tape suitable for high temperatures.
Useful Info
Important points that differentiate it from the previous version are:
- The use of new current regulators in the LED control circuit. This new type increases the protection of the LEDs, especially with regard to spurious and electrical disturbances, which are very common in catering installations (due to the very structure of the installations, with motors of various types).
- The use of a high-performance LED, more resistant to voltage or current surges than the 5730 LED previously used (the smaller the LED, the more resistant the BOND it contains).
- The use of a new circuit developed on 4 independent rows of LEDs.
In the event of a single LED breakage, on a 10 cm module, only one row of LEDs out of the four will be switched off, leaving the other three lit, making this inconvenience almost invisible and thus avoiding an excessive reduction in luminous flux (on a three-module lamp, the breakage of one LED leads to a loss of luminosity of 7 % compared with 33 % with the previous K LAMP).
